Articles, Blog , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , 0 Comments

Articles, Blog , , , , , , , , , , , , , , , , , , , , , 0 Comments

How to replace the Wireless Antennas Before you begin: Remove the display stand, rear cover, motherboard shield, and fans. Removal – CAUTION! Use care when disconnecting the WLAN antenna cables from the WLAN module. A damaged cable or connector can degrade notebook performance. Carefully disconnect the MAIN WLAN antenna cable from the WLAN module by

Read More

Articles, Blog , , , , , , , , , , , , , , , , , , , , , , , , , , , , 14 Comments

Hello All, How are you?? Welcome to your channel Spray Paint By Cristian Today i will paint A Laptop , Yes , A 17″ inch Laptop Will paint the Case Lets Go! Zeus If you liked this video, remember subscribe to my channel, Hit That Bell to be always informed

Articles, Blog , , , , , , , , , , , , , , , , , , , , , , , 1 Comment

How to replace the Hard Disk Drive Assembly Before you begin: Remove the display stand, rear cover, and motherboard shield. Removal – Disconnect the hard disk drive cable from the connector on the motherboard. Remove the hard disk drive cable from the routing channel on the chassis. Remove the four 6 mm P2 Phillips-head screws

Read More

Articles, Blog , , , , , , , , , , , , , , , , , , , , , 0 Comments

How to replace the Fans Before you begin: Remove the display stand, rear cover, and motherboard shield. Removal – Remove the three 6 mm P2 Phillips-head screws that secure the right fan to the chassis. Slide the right fan off the stand offs on the chassis and set it aside. Remove the right fan cable

Read More

Articles, Blog , , , , , , , , , , , , , , , , , , , , , , 0 Comments

How to replace the Motherboard Before you begin: Remove the display stand, rear cover, fans, motherboard shield, WLAN module, thermal module, graphics card, and CPU. Removal – IMPORTANT: Make careful note of the location of all cables connected to the motherboard for later replacement. Disconnect the following cables from the motherboard: #28 backlight cable #30

Read More

Articles, Blog , , , , , , , , , , , , , , , , , , , , , , , , 0 Comments

How to replace the Graphics Card Before you begin: Remove the display stand, rear cover, motherboard shield, and thermal module. Removal – Remove the four 5 mm P2 Phillips-head screws that secure the graphics card to the chassis and motherboard. Carefully lift the graphics card straight up and off to disconnect it from the motherboard

Read More